Thingiverse
Arcade Button Macro Box
door Unknown
18
Downloads
17
Likes
0
Makes
This is my cheap version of a StreamDeck or Macro-Pad using arcade buttons that I found at a retail return store. I originally designed the box as a single piece, but because my RoBo 3D R1 can't print that big, I broke it down into 3 parts that can be screwed together. All in, I think this project would cost me $30 to $35 had I bought everything new from Amazon. My Bill of Materials is as follows:
4x M4x20mm bolts (Not needed if printed in a single piece)
4x M4 nuts (Not needed if printed in a single piece)
1x Arduino Micro 32U4 (I bought HiLetgo and the pinning worked out perfect)
8x 30mm colored arcade buttons
2x 25mm white arcade buttons
Thin wire (I used some 22AWG rgb wire I had left over from previous projects)
40x 2.8mm female spade connectors with insulating sleeve
2x 7-pin JST connectors (I think JST is right, I bought these as 6s LiPo balancing connectors)
Not all the items in my BOM are necessarily required. For example you could skip the spade connectors and j
4x M4x20mm bolts (Not needed if printed in a single piece)
4x M4 nuts (Not needed if printed in a single piece)
1x Arduino Micro 32U4 (I bought HiLetgo and the pinning worked out perfect)
8x 30mm colored arcade buttons
2x 25mm white arcade buttons
Thin wire (I used some 22AWG rgb wire I had left over from previous projects)
40x 2.8mm female spade connectors with insulating sleeve
2x 7-pin JST connectors (I think JST is right, I bought these as 6s LiPo balancing connectors)
Not all the items in my BOM are necessarily required. For example you could skip the spade connectors and j
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!