Arcade Controller Box for EG Starts Arcade Kit

This is a print to create an arcade box for EG Starts Arcade Kit, found here: https://www.amazon.com/dp/B01M2X88QP?psc=1&ref=ppx_yo2ov_dt_b_product_details

It's fairly compact but if you add rubber feet to it, grips the table nicely.

In addition to the kit (and obviously printer) you'll need:
- 4x M3 6mm screws
- 7x M3 16mm screws
- 4x M3 nuts

Optionally, you'll need:
- glue, for the cover on the joystick
- rubber feet, to prevent sliding on a table

Here's the suggested order, or at least the order I completed it in:

1. Print the top at 0.2mm. I used 25% infill to make it stronger and a little heavier, but you can probably get away with less.
2. Print the bottom at 0.28mm. I used 15% infill. I printed with supports for the USB hole. I'm not sure if that was necessary, but the support popped out nicely leaving a well-formed hole for the USB.
3. While bottom is printing - it's a about a 13 hour print - screw in buttons using the hardware from your kit. You do not need to put the lay