Gadgets
Zum Modell
Arcade Joystick mechanism
161
Downloads
131
Likes
1
Makes
This is the base and mechanism for a 3D printed arcade joystick. This is meant to be added into your design (123d source files included) and is not a stand alone item.
Be careful with your tolerances, If the keeper and effector aren't snug on the shaft of the bolt, the joystick will not spring back to center after you move it. The keeper should be able to move up and down the shaft freely, but have minimal wobble
Be careful with your tolerances, If the keeper and effector aren't snug on the shaft of the bolt, the joystick will not spring back to center after you move it. The keeper should be able to move up and down the shaft freely, but have minimal wobble
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!