Thingiverse
Archery - arrowhead & arrow extender
por DanZbo
74
Descargas
60
Likes
0
Makes
### Info
Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.
### Recommended usage:
+ Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. After that It broke in my hand after few seconds.)
+ You can use tape for smooth transition between extender and arrow body or wrap the entire extender.
+ **IMPORTANT**: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability - **recommended**
If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.
Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.
### Recommended usage:
+ Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. After that It broke in my hand after few seconds.)
+ You can use tape for smooth transition between extender and arrow body or wrap the entire extender.
+ **IMPORTANT**: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability - **recommended**
If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.
DanZbo también publica en
99 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
