Archery Bow and Arrow

This is a miniature (8.5" / 22 cm) archery bow and an arrow model that can go with it. I used sewing thread to make the string and glued it on the bow with super glue. It will fire the little arrows (not all that accurately). Some tillering work with a razor blade might be needed to balance the upper and lower limbs.

Designed and created in Blender.

You can print the bow placed back down and turned at 45 degree angle to fit on the bed of an Ender 3 without any support. The arrows should print separately (laying horizontal with fletching vertical and supports under the arrow. I printed them three up at a time.

Both the bow and the arrow should be printed at 100% infill for strength and flexibility.