Thingiverse
Archery - Simple target pins
por DanZbo
44
Descargas
39
Likes
0
Makes
### Info
First time I printed it with small lateral tips, but this damaged the main tip (probably bad slicer settings) - pic. 3, so I removed it, because lateral tips are not necessary.
**no support needed** (except "*target_pin_v2_type_C*" and maybe "*...type_B*")
**Recommended filament**: PLA works fine for me, but PETG or ABS would be better? - text me if you try it
Tested on: http://en.yate.cz/yate-sandwich-start-90x90x7cm-detail-U5T5000101.aspx
First time I printed it with small lateral tips, but this damaged the main tip (probably bad slicer settings) - pic. 3, so I removed it, because lateral tips are not necessary.
**no support needed** (except "*target_pin_v2_type_C*" and maybe "*...type_B*")
**Recommended filament**: PLA works fine for me, but PETG or ABS would be better? - text me if you try it
Tested on: http://en.yate.cz/yate-sandwich-start-90x90x7cm-detail-U5T5000101.aspx
DanZbo también publica en
99 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
