Thingiverse
Archery Target Face Pin
door BuildItMakeIt
28
Downloads
15
Likes
0
Makes
This is an archery target face pin that you can 3d print. The part doesn't require support, but you can add it if you would like so the front pin is supported a little more.
It was designed for .3 mm layer height, and I recommend printing in something with some flex to it. I used PLA+ and it is working great, but if you can print in nylon, I would recommend that. Also you should print it a little hotter than normal (there really aren't important overhangs) so that the plastic on the pin part fuses together well.
You can see the then in use in my archery target build video: https://youtu.be/3jH1nYfO-4o
It was designed for .3 mm layer height, and I recommend printing in something with some flex to it. I used PLA+ and it is working great, but if you can print in nylon, I would recommend that. Also you should print it a little hotter than normal (there really aren't important overhangs) so that the plastic on the pin part fuses together well.
You can see the then in use in my archery target build video: https://youtu.be/3jH1nYfO-4o
BuildItMakeIt publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
