Cults3D
Game
Ver Modelo
Archipelago Insert
1
Descargas
0
Likes
0
Makes
Both (a) and (b) are essentially the same, but (b) has incorporated supports that should be a lot easier to remove than slicer generated supports. So if you print (a) you should probably enable supports in your slicer. If you print (b) then you should disable supports in your slicer and you should enable "print thin walls" otherwise the supports may not be printed - check the preview in your slicer software.
Refer to the images to see which cards goes where.
3) Table Tray
archipelago-table_tray.stl
4) Player Trays
5 x archipelago-player_tray.stl
NB my printed copy was an older version that used vase mode ( in order to save filament). Afterwards I made a 2 wall thick version (using 0.4mm nozzle with line width 0.4mm), and according to my slicer it uses only 2g more the vase mode version, so I dropped the vase mode version (even though it should be plenty strong enough if you don't deliberately mistreat it).
5) Player Screen Holders (optional!)
5 x archipelago-pla
Refer to the images to see which cards goes where.
3) Table Tray
archipelago-table_tray.stl
4) Player Trays
5 x archipelago-player_tray.stl
NB my printed copy was an older version that used vase mode ( in order to save filament). Afterwards I made a 2 wall thick version (using 0.4mm nozzle with line width 0.4mm), and according to my slicer it uses only 2g more the vase mode version, so I dropped the vase mode version (even though it should be plenty strong enough if you don't deliberately mistreat it).
5) Player Screen Holders (optional!)
5 x archipelago-pla
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
