Arducam 8MP Case

Snap together or glue together case for a Arducam 8MP Board camera.

This unit provides a low cost way to get a decent resolution camera to watch your prints.

I have made this cam function with Windows and Linux without extra drivers. Tried and Tested.

Works Great in Klipper, Octoprint, and as a general Webcam.

Back left flat for additional mounting points to be added.

Unit fits the cam PERFECTLY.

There is no need to glue it together. Just clean up the edges with an exacto after printing, and make sure the lens is centered before you snap it together.

It can be glued together for permanent mounting with a small dot of good glue at the 4 corners. Then snap together and press tight until dry.

Tiny, Easy to mount on your printer without getting in the way of critical parts, and even has mic to hear grinding or poor operation type noises. Decent mic too.

NOT the best autofocus. A bit jumpy. Not good for anything youll be using the video from anywhere publ