Arducam Raspberry Pi IR Camera Case Mount

Protect, mount, & aim your Arducam IR camera on your 3d printer! Designed for mounting to either 20x20 or 30x30 extrusion, but would work mounted to a flat plate, as well. This is specifically designed for [this camera](https://www.amazon.com/gp/product/B0834XSLZM), so I am not sure if it will work with others.


Printing:
No special instructions here. Supports aren't necessary unless your printer gives you issues with overhangs. There are single-layer "caps" to the counterbored holes to allow for better printing - just shove a screw, screwdriver, or anything small & pointy through to clear it out before assembling.

Assembly hardware:
- 5x M3 nuts (4x for case, 1x for socket mount)
- 4x M3 x 10-20mm socket head screws for case
- 1x M3 x 12-16mm socket head screw for socket mount

Mounting hardware:
- 2x M3 t-slot nuts (whatever fits your frame)
- 2x M3 x 10-12mm socket head screws

Assembly instructions:
- Insert 4x M3 nuts into back cover
- Install ribbon cable to ca