Arduino Pro Mini Bracket/Mount

Needed a way to mount the pro mini, while still being able to access the pin headers, and remove the arduino if necessary. I also wanted the option to secure the bracket down with screws, without compromising the overall size too much, so have added screw holes under where the board sits.

This mount allows you to use a bare board, or one with pin headers attached.
The bare board slides in from one end, whereas one with pin headers attached can be slotted in at an angle from the top, and pressed into place, as seen in my crudely edited photos.

For reference my knock-off brand pro mini is 18x33mm.
It's a pretty snug fit, so you could probably scale this up on any axis and it should still work fine.