Thingiverse
Argus air pod box
door makruzz
12
Downloads
28
Likes
0
Makes
Storage box for the Voopoo Argus air pods.
The smooth model also doubles as a stand for the mod by putting the lid on the bottom of the box.
The textured version is made with idea maker and printed on the Ender 3.
I printed these in PLA and works good after opening and closing a few time.
They can be a bit difficult to open when new due to small lager defects but opening and closing them a few times makes them smooth.
The grove in the top of the box was intended for a 1mm o-ring to be glued in but i have not tested this.
you can put a small piece of textile tape in the lid to get a rattle free fit.
I have put the Fusion 360 archive file here for you to be able to make your own, maybe put labels on the lid to be able to be able to identify the different pods.
The smooth model also doubles as a stand for the mod by putting the lid on the bottom of the box.
The textured version is made with idea maker and printed on the Ender 3.
I printed these in PLA and works good after opening and closing a few time.
They can be a bit difficult to open when new due to small lager defects but opening and closing them a few times makes them smooth.
The grove in the top of the box was intended for a 1mm o-ring to be glued in but i have not tested this.
you can put a small piece of textile tape in the lid to get a rattle free fit.
I have put the Fusion 360 archive file here for you to be able to make your own, maybe put labels on the lid to be able to be able to identify the different pods.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
