Thingiverse
Ark Nova Magnetic Insert
by ShieldBasher
8
Downloads
6
Likes
0
Makes
remix of the original project by jacques_za.
I've remade basically the entire thing besides the beautiful tile holders, where I've just added some Ark Nova logos.
The player boxes are magnetic, you'll need 2x1mm magnets. In total you'll need to print 4 boxes and 4 lids. There are two versions, push fit and to be glued. The hole for the glued ones is slightly larger to accomodate the magnets, while in the push fit ones you will need to properly align the magnets and then I've used a small hammer and a small wood stick to secure the magnets inside.
For the placement of the tiles, check out the original project.
You'll find the double layer boards here, remixed by me: https://www.thingiverse.com/thing:5962300
Printed with standard PLA on a Bambu Lab P1P.
No brims or supports needed.
Layer height: 0,12mm
Infill: 15% should be enough
I've remade basically the entire thing besides the beautiful tile holders, where I've just added some Ark Nova logos.
The player boxes are magnetic, you'll need 2x1mm magnets. In total you'll need to print 4 boxes and 4 lids. There are two versions, push fit and to be glued. The hole for the glued ones is slightly larger to accomodate the magnets, while in the push fit ones you will need to properly align the magnets and then I've used a small hammer and a small wood stick to secure the magnets inside.
For the placement of the tiles, check out the original project.
You'll find the double layer boards here, remixed by me: https://www.thingiverse.com/thing:5962300
Printed with standard PLA on a Bambu Lab P1P.
No brims or supports needed.
Layer height: 0,12mm
Infill: 15% should be enough
ShieldBasher also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
