Armoured Cable Clip

Cable cleat for approx. 14mm OD cable (3 core 2.5mm - 4mm armoured cable).

Print in PETG or? at 0.3mm layers including first layer.

2 or 3 perimeters with 10-20% infill should be fine.

Once printed heat a bit of pipe or similar with your clip(s) on your heated bed to about 85 degrees, then just fold the clips over the piece of pipe to form them without damaging the filament (see second picture).

Fix with M4 screws or bolts.

If you like or use this design please send me a little support, just a pound or two (or dollars etc) at [https://www.paypal.me/MettaUK]. Thank You.