Arrma Granite Lights

!!!!! Warning attached stl is partial only !!!!!!
Support me by getting full model for free from here (it only takes two clicks)

https://makerworld.com/en/models/148762#profileId-162371

I wanted lights for some night bashing….

To connect to receiver and control from stock remote or any other 3 channel remote you need one of these cheap controllers

https://amzn.to/426o1dk

You'll also need 2 M3x16 screws to connect the rear lights

The Headlights just go around the body posts and i use a small cable tie to tie the wires to the post. The lights should move freely back and forth if pushed but should hold their position. them being able to pivot is what prevents them from breaking while bashing.

Covers are optional. Just watch out for puddles.

Note: Some links are affiliate links that helps me at no cost to you.