Thingiverse
Tools
Go to Model
Arrow Bookmark
227
Downloads
549
Likes
2
Makes
About:
---------------------
This is a remix of the https://www.printables.com/model/344977-bookmark bookmark.
I liked the model , but it needed supports to be printed horizontal , and had issues to print vertically.
Design:
---------------------
Simple arrow shaped bookmark that can clip on pages and the arrow can point to the current paragraph or line you are reading
Printing Instructions:
---------------------
This bookmark has to be printed vertically , and should require a brim , because the base is barely 2 mm wide.
I printed this with 0.6mm nozzle, 0.3mm layer height, but you can choose your prefered print settings.
I would also recommend to use slow print speeds to avoid warping.
---------------------
This is a remix of the https://www.printables.com/model/344977-bookmark bookmark.
I liked the model , but it needed supports to be printed horizontal , and had issues to print vertically.
Design:
---------------------
Simple arrow shaped bookmark that can clip on pages and the arrow can point to the current paragraph or line you are reading
Printing Instructions:
---------------------
This bookmark has to be printed vertically , and should require a brim , because the base is barely 2 mm wide.
I printed this with 0.6mm nozzle, 0.3mm layer height, but you can choose your prefered print settings.
I would also recommend to use slow print speeds to avoid warping.
daarshclicks also publishes on
39 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
