Thingiverse
Articulating Arm Camera Holder
by PedjaS
4
Downloads
6
Likes
0
Makes
This is three part articulating arm allowing easy mounting camera or mobile phone (with appropriate camera adapter). If you need longer arm and more adjusting options you may additionally print middle part an use it to extend arm.
Articulated arm prints as one part but three parts are actually separated after print. You also need to print pair if knobs for 4mm hex nuts with caps.
It is supposed to be used with standard camera mounting pod. I use it with DELL 2412 camera mounting platform (https://www.thingiverse.com/thing:5442167) to attach web camera or mobile phone on top of the monitor for web streaming.
It allows fine leveling of the camera, especially if you have fixed pod, like when mounted on top of the monitor.
It also allows bringing web camera closer if it has to wide lens.
May be used for mounting camera in horizontal position for top view recording or some awkward position if you need it.
Other than printed parts you need two M4-40mm screws and two M4 n
Articulated arm prints as one part but three parts are actually separated after print. You also need to print pair if knobs for 4mm hex nuts with caps.
It is supposed to be used with standard camera mounting pod. I use it with DELL 2412 camera mounting platform (https://www.thingiverse.com/thing:5442167) to attach web camera or mobile phone on top of the monitor for web streaming.
It allows fine leveling of the camera, especially if you have fixed pod, like when mounted on top of the monitor.
It also allows bringing web camera closer if it has to wide lens.
May be used for mounting camera in horizontal position for top view recording or some awkward position if you need it.
Other than printed parts you need two M4-40mm screws and two M4 n
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
