Articulating Arm With Customizable End

UNFINISHED WORK
STILL NEEDS A CLAMP FOR THE BOTTOM

The part is about 8ish inches tall and printing 3 is recommended for desired height.

Print laying flat so layer lines run across the whole length of the part.
Print Diagonal across print bed to ensure complete fit.
5-6 Walls & Top/Bottom
20-25% Infill

Required Hardware
1/4-20 by 1.25 in or longer, holes for bolts are 1/4 in in diameter and may be a tight fit sanding may be required.
1/4-20 Nuts are also required for the bolts/ Wing Nuts are an option however they are not recommended because they are untested.

Assembly
Slide the 2 parts slots into each other until hole can be seen all the way through, sanding may be required. Then insert 1/4-20 bolt then tighten nut until 2 parts support their weight and do not move.