Thingiverse
Artillery Genius - versatile Tool Holder
von Tequis
42
Downloads
23
Likes
1
Makes
A versatile tool holder for Artillery Genius meant to be installed on the top bar to save some desk space.
No additional screws are required, just use the original ones already in place.
Use the mirror feature of your slicer in order to print a tool holder for the other side as well.
The holder has dedicated holes for:
. Basic Allen key set in the range: M5, M4, M3, M2.5, M2
. Spatula slit
. Screwdriver holes
. Additional peg e.g. for tweezers
If you have access to TPU I advice printing it as a two part design:
1) the actual Tool holder
2) a TPU sleeve as "vibration dampener"
If you do not have access to TPU (or any other flexible material) I have attached a file with the One-part-design so you can print it as one piece.
Printer settings:
I advice using Tree-supports for the Spatula-Slit. The other holes do not need any support, therefore you can use support blockers in these areas.
The TPU-Sleeve does not need supports, I do recommend a Brim for the bed ad
No additional screws are required, just use the original ones already in place.
Use the mirror feature of your slicer in order to print a tool holder for the other side as well.
The holder has dedicated holes for:
. Basic Allen key set in the range: M5, M4, M3, M2.5, M2
. Spatula slit
. Screwdriver holes
. Additional peg e.g. for tweezers
If you have access to TPU I advice printing it as a two part design:
1) the actual Tool holder
2) a TPU sleeve as "vibration dampener"
If you do not have access to TPU (or any other flexible material) I have attached a file with the One-part-design so you can print it as one piece.
Printer settings:
I advice using Tree-supports for the Spatula-Slit. The other holes do not need any support, therefore you can use support blockers in these areas.
The TPU-Sleeve does not need supports, I do recommend a Brim for the bed ad
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
