AS5600 Nema 17 Base

Design to put the AS5600 sensor on the top of the Nema 17 Stepper Motor. This design allow to colocate the motor standing without any problem with the sensor, to connect it, you have to use jumpers cable in the hole.

Printing:
Infill: Depending of the use but with 20% its enough
Layer 0.2 it's recommended
Velocity: 40mm/s (PETG material)
Rafts: Doesn't matter
Supports: Only for the screw holes

Use 4 M3x50 to adjust the base to the motor