Ascent 32_CHASSIS_kitV1

When you assemble this, the rear upper links mount to the frame using the last hole in the slider. You'll need to use a nut to hold it on. Do not over tighten. To mount the link riser, first remove that triangular part on top of the diff. (Just remove the top screw of the diff cover and the triangle comes off). Then place the riser and thread the screw through the hole where the rear upper link was originally mounted. Do not over tighten. Now add some adhesive to the bottom of the riser and glue it to the axle housing. I use G6000.

This setup uses the stock skid and the only links you'll be replacing and the rear lower links. You will most likely need to mount the motor rear facing. That will require you to mount the skid 180 degrees from stock.

Give it a try, it's FREE

Disclaimer: l already know there are design flaws. It's a version 1 prototype, and l don't know what l'm doing. Also, the was designed around a rig with a Purple Viper facing to the rear, but should work fine with th