Thingiverse
ASH - Awesome Spool Holder
door grandpamode
12
Downloads
4
Likes
0
Makes
###Why use ASH?
it lets you use big spools without breaking your chinesium printer.
Why not TUSH? - i just thought it was gay that it *had* to be glued together. it takes a bit longer to print but it has a compliant clip thing so any epoxy is optional and used only for stronger attachment, i still recommend it for big spools, put jb weld in the ridge at the bottom or something. (that's why it's there)
###V2 UPDATE
The wheel is an upgrade for old "V1" ASH prints (though i recommend it regardless). V2 deals with spools sticking because of manufacturing issues by adding a beveled edge, so the spool gets pushed back into the rail while keeping it one symmetrical part.
#####▼ bearing guide ▼
requires four (4) #608 ball bearings. [available here](https://www.amazon.com/dp/B07216D1SZ)
1. clean with water
2. displace with wd40
3. lubricate with nuG oil, chain grease, or similar
it lets you use big spools without breaking your chinesium printer.
Why not TUSH? - i just thought it was gay that it *had* to be glued together. it takes a bit longer to print but it has a compliant clip thing so any epoxy is optional and used only for stronger attachment, i still recommend it for big spools, put jb weld in the ridge at the bottom or something. (that's why it's there)
###V2 UPDATE
The wheel is an upgrade for old "V1" ASH prints (though i recommend it regardless). V2 deals with spools sticking because of manufacturing issues by adding a beveled edge, so the spool gets pushed back into the rail while keeping it one symmetrical part.
#####▼ bearing guide ▼
requires four (4) #608 ball bearings. [available here](https://www.amazon.com/dp/B07216D1SZ)
1. clean with water
2. displace with wd40
3. lubricate with nuG oil, chain grease, or similar
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!