Back
Ashtray – 3D printable model from MakerWorld MakerWorld
Other Hobby & DIY

Ashtray

1.7k Downloads
373 Likes
949 Makes
Download Model
这是一个烟灰缸,需要的朋友拿去吧! 注意: 1、打印完成后,请在烟灰缸中加入适量的水。2、香烟吸完时,将香烟插入烟灰缸的小孔,利用烟灰缸中的水将烟头熄灭。请务必确保香烟熄灭了,防止发生火灾,毕竟这个烟灰缸是塑料制品。 This is an ashtray, take it if you need it!be careful:1. After printing, please add an appropriate amount of water to the ashtray.2. After smoking the cigarette, insert it into the small hole of the ashtray and use the water in the ashtray to extinguish the cigarette butt. Please make sure the cigarette is extinguished to prevent a fire, as this ashtray is made of plastic.
Category
Other Hobby & DIY
Source
MakerWorld
Published
06.09.2024
Updated
10.03.2026
Comments
0

Bewertung

Noch keine Bewertungen

Comments

No comments yet – be the first!
More Other Hobby & DIY Models All MakerWorld Models More by Lucky Dragon

Similar Models

6 Suggestions

Add to Collection