Thingiverse
Assassin's Buttons
von Nleinad
0
Downloads
0
Likes
0
Makes
With two $1 valves and this bracket, you can make the Assassin's water bottle by Steve Mould operate with push buttons!
Inserting the silicone stoppers in the ventilation holes of the Assassin's water bottle can be a bit tricky. This accessory reacquires no modification to the bottle and makes it faster and easier to operate the two compartments. Just install the two valves using the 3D printed bracket and push a button to release the liquid of choice. With the valves in place, the flow is reduced a bit.
Components needed: 2 pcs motorcycle fork air bleeder valves (from AliExpress), and 2 pcs M4 nuts with nylon washers.
Source code (.stp & .3dm) is also provided, should you want to modify the design for your own purpose. Please share your prints!
Inserting the silicone stoppers in the ventilation holes of the Assassin's water bottle can be a bit tricky. This accessory reacquires no modification to the bottle and makes it faster and easier to operate the two compartments. Just install the two valves using the 3D printed bracket and push a button to release the liquid of choice. With the valves in place, the flow is reduced a bit.
Components needed: 2 pcs motorcycle fork air bleeder valves (from AliExpress), and 2 pcs M4 nuts with nylon washers.
Source code (.stp & .3dm) is also provided, should you want to modify the design for your own purpose. Please share your prints!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
