Thingiverse
Assault on Hoth Miniatures
von epengr
473
Downloads
318
Likes
3
Makes
I have fond memories of playing West End Games' long out of print [Assault on Hoth](https://boardgamegeek.com/boardgame/3548/assault-hoth-empire-strikes-back) on my friends living room floor for hours.
This project has been in the back of my mind ever since I built my first printer.
The scales are all off, dictated by practicality. The Troops were printed with a 0.25mm extruder tip at 0.2 mm layers. Most of the result was printed with a 0.4mm tip at 0.2 - 0.3 mm layers.
The Snowspeeder is [Jabberwock's model](http://www.thingiverse.com/thing:1290458) modified for easy printing without support.
The Shield Generator is [Vincent1212's model](http://www.thingiverse.com/thing:1174989), scaled down and dropped on a base.
All other models were designed from scratch.
Tips always appreciated...
Enjoy!
This project has been in the back of my mind ever since I built my first printer.
The scales are all off, dictated by practicality. The Troops were printed with a 0.25mm extruder tip at 0.2 mm layers. Most of the result was printed with a 0.4mm tip at 0.2 - 0.3 mm layers.
The Snowspeeder is [Jabberwock's model](http://www.thingiverse.com/thing:1290458) modified for easy printing without support.
The Shield Generator is [Vincent1212's model](http://www.thingiverse.com/thing:1174989), scaled down and dropped on a base.
All other models were designed from scratch.
Tips always appreciated...
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
