Thingiverse
Asthma Inhaler Holster
von kraused53
1
Downloads
0
Likes
0
Makes
This is a very basic wall-mountable holster for my asthma inhaler. I made this so that I will always have an obvious spot to keep it when I get home everyday.
The pocket of the holster is 1.875 x 1.375 inches and 1.5 inches deep. The back is 3.625 inches from the base to the top of the curve. I added a 0.25 inch diameter whole for hanging on a nail or small hook, but a command strip would be more than strong enough to hold the weight of this print. Print with the pocket opening upwards.
This is my first attempt at modeling my own 3d print 😊.
The pocket of the holster is 1.875 x 1.375 inches and 1.5 inches deep. The back is 3.625 inches from the base to the top of the curve. I added a 0.25 inch diameter whole for hanging on a nail or small hook, but a command strip would be more than strong enough to hold the weight of this print. Print with the pocket opening upwards.
This is my first attempt at modeling my own 3d print 😊.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!