Slicer Discord
Astrocam Arrowhead  – 3D printable model from MakerWorld MakerWorld
Other Education Models

Astrocam Arrowhead

1 Downloads
1 Likes
0 Makes
Go to Model
If you have a flash drive camera or the news Estes Astrocam, here are a few nose cone options for you.You'll want a small rubber band or tape to fully secure the camera.For the Thumb drive camera, search Ebay for Thumb or Flash drive cameras.Note: The Micro Camroc uses the Flash Drive Camera. They're not great cameras but boy are they cheap!The BT-5, 20, 40 and 50 will hold the new Estes Astrocam and tilt it at a better recording view angle. Nose cones have a U-tube for attaching the shock cord.The BT-60 rings fit between the nose cone and the body tube. You should tape them to the nose cone BT-55 Astrocam has a opening at the top and bottom that would allow you to thread a shroud line through it so you can suspend it looking down by the parachute.I suggest using supports to print the overhang areas of the nose cone. I've included the 3MF project file incase you want to use that. And if you have TWO Astrocams - this nose cone if for YOU! The BT-50 version of the Arrowhead T
Category
Other Education Models
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection