Astromech Power Coupler Overlays

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/iGXZheqJ6xX

Fold a length of clear or masking tape into a loop to make it like double sided tape. Place your parts onto of the tape and then apply it to a sheet of paper, or a box. Take this outside and lightly spray a layer or two of primer onto the parts. Wait till the primer dries, then apply your paint color of choice. Once that is dry remove the parts from the tape. If there is extra paint that comes off with the part clean it up by placing the part on top of cardboard and use a disposable box cutter to trim it off by running the blade along the edge of the part. It will leave you with a super clean edge. For the circle, run a piece of rolled up sandpaper in the center to clean that area up if needed. ENJOY!!!!