Astroprint and Simplify3D

** Update ** Make sure you give your astrobox/raspberrypi a static ip, because if the ip changes this will have to be redone (at least the keygen part).

Hey everyone! GoldenGears here, I wanted to share with you something I was able to throw together. I kept seeing people setting their simplify3D processes to auto upload to octoprint using cURL and I wanted to be able to do the same with Astroprint. Below is my step by step directions (written for mac but can be adapted for other platforms) on how to achieve this. If you have any questions or ways you think it could be improved let me know. eventually I would like it to auto upload and print but I haven;t quite figured out how to remotely tell the astrobox to print. Anyways here you go!

First open up terminal

enter: ssh pi@your_pi_ip
(replace "your_pi_ip" with the ip address of your AstroBox)

Enter the password for your raspberry pi (Default password: raspberry)

enter: sudo nano /etc/ssh/sshd_config

Find the line tha