Asuka lithophane

项目：asuka.hfp以0.08mm的层高度以0.16mm的层为0.08mm的100％填充物打印该型号的尺寸为106.3x200mm您可以在0.24mm的最小深度以下以较高的高度打印最大深度为2mm，实际深度为1.9mm使用的细丝：PETG BAMBULAB基本黑色传输距离：2.7PETG BAMBULAB基本红色传输距离：2.7PETG BAMBULAB基本黄色传输距离：2.7PETG BAMBULAB基本白色传输距离：5.2该印刷使用4个独特的丝交换说明：从黑色开始在第7层（0.64mm）交换至红色在第12层（1.04mm）交换为黄色在第18层（1.52毫米）换成白色。--------------------------------------------------------------------Project: asuka.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 106.3x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.24mmThe Max Depth is 2mm and the Actual Depth is 1.9mmFilaments Used: PETG BambuLab Basic black Transmission Distance: 2.7 PETG BambuLab Basic red Transmission Distance: 2.7 PETG BambuLab Basic yellow Transmission Distance: 2.7 PETG BambuLab Basic white Transmission Distance: 5.2This print uses 4 unique filamentsSwap Instructions: Start with black At layer #7 (0.64mm) swap to red At layer #12 (1.04mm) swap to yellow At layer #18 (1.52mm) swap to