Atari 2600+ Joystick and Rubber Boot Replacement

My dog chewed up my new Atari 2600+ joystick, so I went looking for STLs for replacement parts and was unable to find any for the new 2600+ joystick, the CX40+. I printed the joystick in PLA and found that using the Bambu PLA support material I was able to very easily remove the support without damaging the parts on the bottom that interface with the PCB. The boot was printed in a generic TPU, with support. I didn't have any issues removing the support, but your mileage may vary since I just used whatever TPU I had laying around. Installation is very straight forward, remove the 4 screws on the bottom of the joystick and from there everything is accessible and straight forward.