Atari Gamestation Pro Paddle Knob

I picked up an Atari Gamestation Pro this past week, and immediately I noticed that the paddle knob, while neat, was far too small. So I pulled up Tinkercad and threw together this design. It locks down into the grooves on the side of the original knob, but is easy enough to pop back off if needed. There are two different versions, one that's a single, monochrome part, and another that is broken into three separate parts (that print together). The three separate parts allow you to select different colors of filament for each part (the knob, the circle on the top face, and the ring around the bottom). While I love the Gamestation Pro, this small change has worked wonders for my scores. There's much better control with a larger wheel. Enjoy!