Atarimax SIO2USB Adapter case

Case designed for the Atarimax SIO2USB Adapter. I designed this for a friend. The original design was styled after a Sony PSP power supply brick. But I added the diagonal grooves after seeing some on-line examples of other cases. This is a snap fit case and feels very sturdy. No screws required. You will want to make sure your printer is calibrated properly so the halves fit together properly.

Edit: I added a vented top for those that are concerned about heat.

Edit 2: I added a wider version for SIO2USB Adapters with a different SIO port with wider tabs. It's 8mm wider. Hopefully this accommodates the board without the need to trim the tabs off the SIO port. I am unable to test this, so if you print this version, please post your results.

Edit 3: I redesigned the light pipes for the wide model to accommodate taller LEDs. These light pipes should fit around the LEDs and allow them to go up into the pipes.