Atomic Pi Quick Printing Stand Options - Case Alternative

I noticed that a lot of the options for cases for the Atomic Pi take a long time to print. Nothing wrong with that, but sometimes you just want to get something up and running and not spend a day or two printing a case to protect it its vulnerable belly.

So I made these as a couple of quick options.

One option is a little one piece base with an M shaped brace on the bottom (intended for use with one of the Baby Breakout Boards. I believe it should work with either.

The other option is just the pillars without the M shaped brace.

There's also an option on the pillars:

One type attaches with 3mm screw.

The other has a 3mm pin that will stick through the holes in the board that can be (somewhat) secured with 3mm nuts (they will sort of thread on, but don't get super tight). Or possibly could be melted with a hot knife to mushroom the top to hold on.

There is also provision for printing flexible feet to pop into the sockets on the bottom of the pillars/the bottom of t