AtomRC Dolphin DJI O4 Pro Base

No need for fan, just a proper cut-out of the lid and good aligned mounting.

Print all parts flat. The angled part is just because of how I designed it.

You might need to rethread the M3 of the lower base.
I am using plastic screws, because they are sufficient and light (25 mm length needed).
Mind the slight angle of the threads in the base when rethreading or mounting.

The DJO O4 pro is mounted from the bottom.
Remove the original M2 screws and mount with longer ones (10 mm minimum) onto the upper base.

The cut-out is following the existing cut-out for the vent.
Make the cut-out for the DJI O4 pro first.
Then mount everything together and add two longer M2 screws to the top of the DJI O4 pro to allow you grabbing it.
Hold the DJI O4 pro in place inside the lid, apply glue to the mount and position where it should be.
Wait for the glue to cure.