AtomRC Dolphin Nose Mount

Since the pictures are sparse a little more text:

First: You might need to re-thread the M3 threads in "Mount Guide".

Also: You need to remove the wooden plate in the front fuselage to get the next steps working.

"Mount Nose" shall be glued into the nose with CA. To allow a good alignment screw the "Mount Helper" onto the "Mount Nose" while gluing.
Afterwards "Mount Helper" not needed anymore. Check the picture.

Screw some M3 screws into the "Mount Nose" just so far that they still touch the fuselage very slightly when the nose is attached to the fuselage. The depth is different for left and right.

Now apply some paint (e.g., acrylic pen paint) onto the heads of the M3 screws and attach the nose to get some position markings for the drilling on the fuselage.

Next step is to get two 5 or 6 mm holes (the EPP is compressible) perpendicular (try hard to get this good on both axis) into fuselage at the place of the paint markings created above. Start with an 2 mm or 3 mm drill, that's