AtomRC Dolphin Pro Flush Motor Mount

A motor mount that combines air intake for better cooling and counterweight for the tail. Say goodbye to motor overheating!

---

### Features
- Integrated air intake for cooling ; no more motor overheating, even with stock 6S setup!
- Separate motor firewall design, for localized high-temperature material usage.
- Flushed out tail for lower noise level, due to less turbulent airflow over prop.
- Doubles as tail counterweight for 6S1P 5200mAh LiPo or 6S2P 10Ah 21700 setups.
- Designed around motors with 19x19mm M3 mounts; allows high-pitch props to be used.

---

### Tips
- This part assumes you are using 6S setup; 4S 20Ah setups maybe possible to use this, I believe?
- For battery weights around ~750g, target for 120g printed part weight; maximum attainable printed weight is estimated to be around 270g.
- These parts might serve as basis for 70mm EDF conversion kit later...?

---

### Required Parts
- 4x M3 60mm bolt (for motor mounting)
- 4x M3 30mm bolt (for fuselage mounting)

--