AtomRC Swordfish DJI O3 mount

the upper part also works with my tail cam mount for the volantex phoenix v2 2000: https://makerworld.com/en/models/593401 the upper parts are actually identical improvements: better look :D magnets instead of screws lower profile easier access more robust lighter angled - as is the swordfish's vtx bay modular swappable - top part fits on my volantex phoenix base too for example printing: supports required for both parts sadly hybrid tree supports for top, snug normal supports for bottom 0.2mm layer height petg or better ≤20% infill sufficient assembly: requires 4 or 8 5x5x3/5x5x5 neodymium magnets antenna clips in place, air unit should fit in cavity of top/bottom part stick base down with double sided tape cable should easily fit through slot let it (magnetically) snap together insert the magnets CORRECTLY, once in, you can't really remove them without destroying the part if you use 5x5x3 magnets, make sure they're seated flush against the mating surface V3 might include a pan-servo