AtomRC Swordfish O3 Nose Mount

SummaryI modified Gizfpv's excellent nose mount to work with the DJI O3. It works well. There are a few considerations:1 - Screw holes2 - Mounting the O33 - Top vent4 - Ballast5 - Antenna6 - Hardware7 - Supports8 - InstructionsFor #1 (screw holes), the diameter of the mounting holes for the screws was too small initially. I drilled mine out and updated the design - it should work better, but I haven't tested it (don't want to reprint and waste). If they're too small, just use a 1/8" drill bit.2 - Mounting the O3. I chose not to hard mount the air unit (the camera itself is hard mounted of course). I didn't have the right sized screws to hard mount the O3 and it doesn't matter much anyway. I added little side bars to hold it in place in the design. To reduce vertical movement, I just stuck some padded tape to the top of unit and left on the backing, so it could slide in and out. It's fairly well mechanically secured.3 - Top vent. The air coming in the nos