ATORCH 150W Electronic Load Case - Remix

Just a couple of small tweaks were made to this model from kaz3d, all credit to him for the case design. I had an issue with the right side cover screw rubbing and interfering with the lower pot, just enough to be annoying and not allow for smooth operation. I added countersunk holes to the bottom, which hides the cover screws. I also did this for the top screw holes, though I screwed the circuit board down from the top. For the top piece, I eliminated the screw holes and since I was making changes, added a small lip to shore up the Micro/Mini/C ports a bit. I used #6 sheet metal screws, (2) 3/8", (2) 3/4".