Atreus 44 key variant

Based on https://github.com/profet23/atreus62/tree/master/case

More info: https://imgur.com/a/lAj4I

Print two extra layer v0s and one of everything else. The extra layer v0 goes on top of the bottom plate (I didn't make the walls tall enough oops). I used Gorilla Glue to glue the pieces together. M3x12mm screws to attach the plate to the case.

"halfmm shorter" refers to the lip; I shrunk it in the x direction by 0.5mm so the sides are slightly more symmetrical.

I recommend printing a small part of the switch plate to test the fit. I found printing 103% scale to be a very tight fit, and 104% to be fairly loose (hot glue needed).