Thingiverse
Au from Spelunky 2
von Daxarr
3
Downloads
5
Likes
0
Makes
The playable character Au from Spelunky 2.
Recommended to scale up to ~7cm tall to allow arm supports to print properly. Generate supports everywhere above 70 degrees to prevent front and back head supports from joining together under the legs. Print with a brim to prevent arm supports from disconnecting from the build plate.
If you use PLA+ like I did, recommend printing at 210°C to prevent clogging.
Commissioned by [arvindkumar849](https://www.fiverr.com/arvindkumar849) on fiverr.
Recommended to scale up to ~7cm tall to allow arm supports to print properly. Generate supports everywhere above 70 degrees to prevent front and back head supports from joining together under the legs. Print with a brim to prevent arm supports from disconnecting from the build plate.
If you use PLA+ like I did, recommend printing at 210°C to prevent clogging.
Commissioned by [arvindkumar849](https://www.fiverr.com/arvindkumar849) on fiverr.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
