Audient ID14 MK2 Interface Riser Brackets

I recently bought a new Interface from Audient and its sitting below my screen at the end of the Desk. Since the working angle was a little bit odd for me and I don't like these ugly table risers I thought I integrate this easily into the design of the interface. Every cable is still accessible and guitar cable are also easy to plug in. Be aware that the whole interface gets rised by around 4cm to around (9cm of total height). There is a 15deg and a 20deg Version included. At the bottom you can find deepenings for 8mm wide rubber feet. I added a strutted Version with some minor design improvements. When I moved around the interface the sides sometimes slipped off. For this Version you will need a Soldering Iron, two M3 Melt-In Threads as well as two 6-8mm long M3 Cylinderscrews. Melt in the Threads into the strut until flush, clip it on your ID14 and screw the sides on! Please also find my ID24 version here https://makerworld.com/de/models/2202985-audient-id24-mk2-riser-stand