Thingiverse
Audio Switch V1
von dklon
7
Downloads
4
Likes
1
Makes
I had wanted and needed an audio source switch. So, I decided to make one and learn something rather than buy something off-the-shelf.
This particular case is designed for 3.5mm diameter female audio jacks and a single DPDT switch on top. Other than that, all you need is some wire, soldering, and a little patience.
The case can be modified in OpenSCAD with the variables at the top. I ended up going through a couple of revisions because I needed more room to get my big fingers in. The height of the case is about as small as you can go with a DPDT switch and all of the accompanying wires.
This particular case is designed for 3.5mm diameter female audio jacks and a single DPDT switch on top. Other than that, all you need is some wire, soldering, and a little patience.
The case can be modified in OpenSCAD with the variables at the top. I ended up going through a couple of revisions because I needed more room to get my big fingers in. The height of the case is about as small as you can go with a DPDT switch and all of the accompanying wires.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
