Aurora A3 Extruder Mount

This bracket mounts behind the nozzle fan on an Aurora A3 to provide some hard points. I printed using PETG to provide a little heat resistance in the nozzle area, but suspect PLA would work just fine. The fan holes came out a little small so I reamed them out with a 1/8 inch drill bit. Note that as designed this will take the nozzle fan 1mm more distant from the nozzle.


* Upper right has holes for a zip tie strain relief
* Upper left has a dial indicator mount

Source files are provided. Future direction:
* Mating bracket between Claghorn's cable chain http://www.thingiverse.com/thing:611593 and Dinster's Aurora mount http://www.thingiverse.com/thing:2030736
Version 2 has parameterized hardpoints. Added is an untested beta proximity sensor mount for a LJ12A3-4-Z/BX (Note that the fan bows out on the lower left so would need to extend the width there.)