Thingiverse
Aurora A3 Top Filament Guide
by servant
2
Downloads
2
Likes
0
Makes
A Filament Guide that clips over the top of an Aurora A3 printer to guide the filament to the extruder. It works well with the filament spool mounted on top of the printer.
The hole is for running the filament through, but the filament needed to be removed from the extruder.
The groove is designed to allow guide the filament inside a large gap without removing the filament from the extruder.
After printing, just turn the part upside down, and clip on an Aurora A3 printer right above the LCD display.
The hole is for running the filament through, but the filament needed to be removed from the extruder.
The groove is designed to allow guide the filament inside a large gap without removing the filament from the extruder.
After printing, just turn the part upside down, and clip on an Aurora A3 printer right above the LCD display.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
