Thingiverse
Auto bed-leveling servo mount
door stephenrc
77
Downloads
46
Likes
0
Makes
A mount for a z-axis servo to a x-carriage. This is not specific to any carriage. I just drilled a couple of holes to mount it on the carriage. The scad file is set for a Temco CN0097 micro switch. It's offset to have the roller inline with the pivot.
1/25/2014
Updated the servo mount scad file to make one that can fit a fan mount. Also, the z stop servo mount has been changed to shift the switch part to either side of the horn.
2/23/2014
Made the z stop servo mount thicker (4mm).
Added countersinks to the mounting holes for the servo, the mounting screw would obstruct the lever.
1/25/2014
Updated the servo mount scad file to make one that can fit a fan mount. Also, the z stop servo mount has been changed to shift the switch part to either side of the horn.
2/23/2014
Made the z stop servo mount thicker (4mm).
Added countersinks to the mounting holes for the servo, the mounting screw would obstruct the lever.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
