Auto level probe E3D V6 zero x y offset

Once I added a glass plate to my heated bed I lost the use of my inductive probe, which I wasn't the biggest fan of to begin with. With no z probe I became pretty good at leveling my bed manually and quickly but would always seem to have one or two spots that were just not quite perfect usually around 0.1 - 0.15 mm different from the rest of the bed. Since my printer kit came with an extra end stop I decided to try to put it to use as a removable Z-Level probe and use z correction to try and get the last little distortion out of my bed.

I designed this to easily slide on and off the heater block of an E3D V6 hotend. Once this is one the switch is positioned directly below the nozzle with a z height of around 15 mm. I did add a small bend to the switch lever to give myself a few more mm of clearance from the bed.

I'm using Repeiter Frimware with the probe mounted and bed heated, I can quickly verify my z offset and run an auto level (g32 s2) and z correction (g33 s2). Once this is