Thingiverse
Auto-level sensor holder, for printrbot Simple 2014
door bres55
20
Downloads
6
Likes
0
Makes
My original version of the probe-sensor holder, distorted badly with heat, see last picture. So I had another go.
This time I decided to strengthen the holder with some metal support. I originally was thinking of using coathanger wire, but a look in my odds and ends draw found a 65mm nail, it's 2.5mm diameter.
This nail sits inside the main body. I have used it for about a week now and whilst it has bent slightly, I believe it will hold up.
With only a week of test time this will stay as a work in progress for now.
This is for the Printrbot Simple 2014 with wooden extruder.
28/05/2015
I never did get Auto-levelling to work CONSISTENTLY, go here to see how I went back to manual levelling.
Bed Levelling/Height adjusting screw/clips
http://www.thingiverse.com/thing:850245
This time I decided to strengthen the holder with some metal support. I originally was thinking of using coathanger wire, but a look in my odds and ends draw found a 65mm nail, it's 2.5mm diameter.
This nail sits inside the main body. I have used it for about a week now and whilst it has bent slightly, I believe it will hold up.
With only a week of test time this will stay as a work in progress for now.
This is for the Printrbot Simple 2014 with wooden extruder.
28/05/2015
I never did get Auto-levelling to work CONSISTENTLY, go here to see how I went back to manual levelling.
Bed Levelling/Height adjusting screw/clips
http://www.thingiverse.com/thing:850245
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
