AUTO OFF Switch for CR6-SE

Hello,
I made this Auto Off Switch for the CR6-SE because i wanted to shut down the printer after he is finished, so the fan wont spin the hole time until i get Home!
With this Switch you just disconect the Old Switch, wire the new one up and Mount it on the X Axis as seen in Picture 3. than just go into your slicer an enter the following Text in the End G-Code:


M84 Y E ;Disable all steppers but Z and X
G4 S180 ;Wait 180 Seconds to let the Hotend Cool down a bit
G0 X234 ;Move Against Power Switch to Shut Down the Printer